Anti-fog guide

Swimming goggles fog up because of condensation forming on the inside of the lenses. This is either perspiration or water vapour from your skin. Therefore, it is likely to be worse if you are exerting yourself.

Most swimming goggles will be sold as ‘anti-fog’ treated which means they have a silicone film applied to the inside of the goggles. This helps prevent water ‘sticking’ to the goggles, instead it runs off the lenses, thus preventing fogging. 

However, goggles can still fog up for a variety of reasons. 

• The anti-fog treatments become less effective over time.
• The anti-fog treatment has come off.
• A lot of moisture is being produced so the anti-fog cannot handle it all.

Obviously you can’t stop yourself from generating heat and water vapour, so how do you stop/ minimise the problem of goggles fogging up? 

1. Put the goggles on while they and you are dry. 
   Often difficult to achieve but this can minimise any extra moisture between you and the inside of the goggles.
2. Spit on the inside of the goggles. 
   Slightly unsavoury perhaps but many people find that this works.
3. Use an anti-fog spray 
   These sprays contain a hydro-phobic solution which repels water from the goggle lens causing it to run off rather than form a mist/fog. They generally have to be used before each swim, sprayed onto the inner surface, very gently distributed across the lens surface with the pad of your fingertip, rinsed in the pool or under a tap and off you go. (They are not the same as a glasses cleaning/anti-fog spray).

Personally, I find the anti-fog in a new goggle works well but generally for only a matter of a few weeks/months. After that I use an anti-fog spray before every swim and find that solves the problem. 

Watch a demonstration showing how to apply anti-fog below ↓↓↓

Diving mask lenses are much more robust than swimming goggle ones because they are usually made of glass and do not have a silicone anti-fog layer. This means you can clean them more easily with regular lens cleaning products but avoid solvent-based ones as this could damage the silicone seal or skirt. 
 

If you find your mask fogs up, we suggest you consider an anti-fog gel. It’s highly concentrated, so a little goes a long way and is often effective through multiple dives. Use in any water temperature, in any conditions and it won’t harm silicone or rubber mask frames.